Catálogo-2-STAUFF-Conexões

296 www.stauff.com/2/pt/#296 R Certificados, homologações e declarações Catálogo 2 § Edição 08/2019 Apêndice Técnico This is a copyofan electronicdocument. In theeventofanyconflictor ambiguitybetween thecopy and the electronicdocument, which is retained andpublishedbyLloyd'sRegister, theoriginal electronicandcertified version shall alwaysprevail. Certificate No. 15/20081 Issue Date 19 August 2015 Expiry Date 18 August 2020 Sheet 1 of 2 Torsten Schroeder Hamburg Technical Support Office Lloyd’s Register EMEA Lloyd’s Register EMEA 71 Fenchurch Street, London EC3M 4BS Lloyd's Register EMEA Is a subsidiary of Lloyd's Register Group Lloyd's Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as the 'Lloyd's Register'. Lloyd's Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Lloyd's Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. Type Approval Certificate This is to certify that the undernoted product(s) has/have been tested with satisfactory results in accordance with the relevant requirements of the Lloyd’s Register Type Approval System. This certificate is issued to: PRODUCER Walter Stauffenberg Im Ehrenfeld 4 58791 Werdohl Germany DESCRIPTION Carbon steel (C15, C22, St35, S235JR2 and 11SMnPB30K+C) high pressure 24° compression couplings with or without seals sensitive to heat as per Stauff Catalogue 01/2015, TYPES STAUFF LL (very light gauge), L (light gauge) and S (heavy gauge) APPLICATION For pressure pipes in the marine, offshore and industrial environment. Restrictions - Bulkhead couplings are not to be used on watertight bulkheads, gastight bulkheads and for “A”, “B” fire class divisions. - Couplings with seals sensitive to heat are not acceptable in the following locations : 1. Starting/control air and CO 2 systems. 2. Inside machinery spaces of category A or accommodation spaces for :- a. Main lines of inert gas systems. b. Pipe systems for flammable liquids including corresponding vent and sounding pipes. 3. Fire main, water spray and sprinkler systems or similar which are not always filled with water.