Catalogue 1 - STAUFF Clamps

122 www.stauff.com/1/en/#122 J Order Code Saddle Clamp ZR-518-SA73-BK Standard Material Thermoplastic Elastomer (73 Shore-A) Colour: Black See pages 154 / 155 for properties and technical information. Min/Max Outside Diameters * Tightening Strap Dimensions Pipe / Tube (Not Included in Scope of Delivery) Ø D1 Ø D2 Length Width (mm) (in) (mm) (in) (mm) (in) (mm) (in) 10 ... 22 .39 ... .87 50 ... 70 1.96 ... 2.76 196 ... 254 7.71 ... 10.00 13 .51 60 ... 80 2.36 ... 3.15 225 ... 284 8.86 ... 11.18 70 ... 90 2.76 ... 3.54 254 ... 314 10.00 ... 12.36 80 ... 105 3.15 ... 4.13 284 ... 359 11.18 ... 14.13 90 ... 120 3.54 ... 4.72 314 ... 404 12.36 ... 15.90 105 ... 140 4.13 ... 5.51 359 ... 464 14.13 ... 18.27 125 ... 160 4.92 ... 6.30 419 ... 525 16.50 ... 20.66 145 ... 180 5.71 ... 7.09 479 ... 586 18.86 ... 23.07 165 ... 200 6.50 ... 7.87 540 ... 647 21.26 ... 25.47 * Ø D1 depending on Ø D2! 71 2.80 23 .91 30 1.18 12 .47 Saddle / Piggyback Clamps Saddle / Piggyback Clamps Type ZR Type ZR saddle clamps from STAUFF allow direct fixing and safe guiding of pipes, tubes and hoses on hydraulic cylinders and other round or oval structures, without causing damage to their strength or integrity as with screw-fixing or welding and without preparation or reworking of the surface coating. The simple system also allows a pipe, tube or hose with a small outer diameter to be installed on top of a significantly larger one. The position can be adjusted at any time thanks to free axial and radial positioning of the clamps on the structure. This also makes the system suitable for retrofitting. The standard version ZR-518 made of thermoplastic elastomer material covers diameters in a range from 50 to 200 mm / 1.96 to 7.87 in for the cylinder and from 10 to 22 mm / .39 to .87 inch for the attached tube or hose. The diameters to be covered are used to calculate the overall length of the required tightening straps or the dimensions of the steel strap or worm drive hose clamp, e.g. according to DIN 3017. STAUFF meets deviating requirements with numerous other variants which were implemented in the past and can be manufactured again at any time. If required, customised clamps can be developed for specific requirements or manufactured based on drawings and models provided. Please contact STAUFF for further information. Dimensional drawings: All dimensions in mm (in). Catalogue 1 § Edition 08/2019 Saddle / Piggyback Clamps

RkJQdWJsaXNoZXIy ODUyNzU=